195mm clock stand designed for Hueforge (or any) images. Wall hang or use the optional stand. Use the Loki image, or follow the directions to make your own Hueforge image into a clock face. I used these clock movements. 4-6 3x6mm (or 3x8) hex screws. (Or glue the clock face on.) There are two profiles, one for the clock case and one for the Loki image. The clock case is straightforward and required a minimal amount of support under the flat mounting surface. They are easy to remove with a pair of needle nose pliers. The Loki image was printed with IIIDMax White, Black, Night Gray, Space Gray and Red at .08mm layer height.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm

Filaments Used:
PLA+ IIIDMax Black Transmission Distance: 0.9
PLA+ IIIDMax Red Transmission Distance: 2.8
PLA+ IIIDMax Night Gray Transmission Distance: 2
PLA+ IIIDMax Space Gray Transmission Distance: 4.5
PLA+ IIIDMax White Transmission Distance: 7

Swap Instructions:
Start with Black
At layer #16 (1.4mm) swap to Red (For height range modifier method use 1.32)
At layer #19 (1.64mm) swap to Night Gray (For height range modifier method use 1.56)
At layer #22 (1.88mm) swap to Space Gray (For height range modifier method use 1.8)
At layer #27 (2.28mm) swap to White for the rest. (For height range modifier method use 2.2)

Instructions to use your own Hueforge image.