I made a hueforged picture of the car of my wife, an toyota auris hybrid made in 2012. If you like it, have fun ;)

If you are missing a shelf to put the picture or the other Hueforge pictures on the wall, take a look at my HueShelf ;)

Instructions:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA Generic Black Transmission Distance: 0.3
PLA Generic Red Transmission Distance: 5
PLA Generic Dark Gray Transmission Distance: 2.5
PLA Generic Gray Transmission Distance: 3
PLA Generic White Transmission Distance: 6

Swap Instructions:
Start with Black
At layer #7 (0.64mm) swap to Red
At layer #10 (0.88mm) swap to Gray
At layer #11 (0.96mm) swap to Gray
At layer #17 (1.44mm) swap to White for the rest.

Share your results with us!