Failed to feed the filament into the toolhead FIX
I have found out that the issue for me was a slight bent where filament goes into the PTFE coupler on the back. This simple print straightens the tube just enough (about 15mm) to make it go in smoothly.
Printing instructions
- Print in any material that you see fit, personally I went with PLA
- I already pre-supported the file (added custom “brims” that you can easily peel away)
- You need three zip ties - there are files for 3,4 and 5mm thick ones
Please, do give me a feedback if it helped you!
My Twitter :)
In case you have any requests, feel free to send me a message and I will try to help you out!