In short, this is a box organizer for the board game Dead of Winter - the Long Night based on my previous set (https://makerworld.com/en/models/73867) for the original Dead of Winter. Again, this can still be printed on a smaller (150 CM x 150 CM) print bed. (If you have a larger print bed, just throw more objects on there, my dude.) 1st Player knife from http://www.thingiverse.com/thing:1083817
Here is the buildsheet for a complete set;
1 x tLN_card_box_1
1 x tLN_card_box_2
1 x tLN_card_box_3
1 x tLN_1-cell_tall_box
1 x tLN_2-cell_tall_box
3 x tLN_3-cell_bits_box
1 x tLN_2-cell_bits_box
1 x tLN_1-cell_bits_box
(Optional)
1 x tLN_1st_player
And here is what goes in each;
tLN_card_box_1 (The setup cards)
tLN_card_box_2 (The location Cards)
tLN_card_box_3 (The main cards, this should go on the table during play)
tLN_1-cell_tall_box
tLN_2-cell_tall_box
tLN_3-cell_bits_box #1 (This should go on the table during play)
tLN_3-cell_bits_box #2 (This should go on the table during play)
tLN_3-cell_bits_box #3 (This should go on the table during play)
1 x tLN_2-cell_bits_box (This should go on the table during play)
1 x tLN_1-cell_bits_box (This should go on the table during play)
Rafts:
Doesn't Matter
Supports:
No
Infill:
Low (10%)
Notes:
Watch your wall thickness when slicing, this can lead to delamination, and separation.