BambuLabs IKEA Skadis 5 Plate Holder with Logo
Copyright Claim
BambuLabs IKEA Skadis 5 Plate Holder with Logo
Boost
38
104
46
Print Profile(2)
Default, best print layer sideways.
Designer
1.5 h
1 plate
BAMBU LOGO FIRST > 0.2mm layer, 6 walls, 25% infill
2.5 h
1 plate
Boost
38
104
46
0
201
157
Released
Description
A simple 5 plate holder to hold up to 5 build plates on the IKEA Skadis pegboard holder, infused with the BLAB's logo.
Comment & Rating (46)
All
Print Profile
Default, best print layer sideways.
Good Print Quality, but Slight Fitting Issues
I gave the Bambulabs Ikea Skadis 5 Plate Holder with Logo a rating of 4 out of 5 stars. The printing with the profile went smoothly, but I deducted one star because the holders don't fit perfectly. The plates wobble slightly and tilt either backward or forward. Adjusting the gap dimensions might be beneficial—not too tight to risk damage, but enough to minimize the wobbling.
The designer has replied
0
Reply
thanks but looks like you're using non OEM plates anyway so they're typically thinner.
0
Reply
Print Profile
Default, best print layer sideways.
Works great. Printed PETG transparent strength setting. Only holds 4 plates though not 5…
The designer has replied
0
Reply
Thanks. More than one plate will fit in the front/back slots when oriented right.
0
Reply
Print Profile
Default, best print layer sideways.
Minimalistisches Modell, schnell gedruckt, passt perfekt
0
Reply
Print Profile
Default, best print layer sideways.
While i like the model, i think its not really great printable in it´s current state.
1. One of the holder for the skadis popped right off while removing the support.
2. The fittings are not great, for the holder, They are too tight on the edges, and too loose on the depth.
3. I have to agree that even the original plates are too wobbly inside the holder. Testes with original Textured PEI and High Temperature plate.
4. The slots nearing the back get too low, this is fine if you have a counter plate on top, but not for free swinging that loose.
Sadly it´s not usable in that state. I am happy to review my rating when the model gets updated.
0
Reply
Print Profile
Default, best print layer sideways.
Perfect, thank you
(Edited)
0
Reply
Print Profile
Default, best print layer sideways.
looks great and perfect for my plates
0
Reply
Print Profile
Default, best print layer sideways.
(Edited)
0
Reply
Print Profile
Default, best print layer sideways.
0
Reply
Print Profile
Default, best print layer sideways.
0
Reply
Print Profile
Default, best print layer sideways.
the slots for the plates could have been a bit tighter for a better fit, but its still very good
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld