This printed great the first time. All of the prices fit together with no sanding or adjustment needed. printed in a PLA+ glow filament so it should be easy to find the disks at night!
I printed using PLA Metal and on default settings. Unfortunately I also kept supports on which they were very difficult to remove inside the handle. I reprinted another handle later to see the difference and supports are definitely NOT required. They function awesome! I used a larger rubber band and doubled it down to make it fit. When I put the filament inside the hinge area I also used a torch to melt the ends and basically rivet the filament to the side of the handle. It's removable still.
A really fun toy. Easy to print and put together. Though my better half was not too keen about me shoot little disc around the house. 😂 Really fun to play and would give 6 stars if it was ever available.
3 Color A1 Mini Updated Trigger 0.2mm layer, 2 walls, 15% infill
Some artifact striping in the print and next disk doesn't slide down in place completely despite tight rubberband. Apart from that nice design and shoots nicely.
what seam setting did you use? I would say try calibrating your filament if you don't have an X1 and in your filament profile turn on retraction and wiping when change layer. This looks like a printer calibration or slicer setting issue, not the model.
Printed impressively well and shoots impressively well. It shoots about 50 ft. not bad for a fast print that only took 3 hours including the 6 discs. Smart way off creating a disc shooter.
trigger was extra sticky and hard to pull to shoot ...was a little but difficult to get the trigger with the bow clipped on properly to get a smoother trigger press but overall good thanks
Yes, you're right. The fit between the spring and the trigger is a bit tight, but it has always worked well with a Bambulab Printer. If it doesn't fit, you can trim the Trigger with a knife.