The orignial design was designed for Hornady dies. I have Hornady, but found the holes to be a little to big. These are designed for Hornady dies with a base not to exceed 24.5mm. The original file holes were 29mm, and when I put the die in them they wouldn't sit up straight.

I also redesigned the peg hooks so that I did not have to use supports.. It may make them look better, but it's not needed.

Print Settings:

Acceleration - 7500 mm/s

Infill - 5%

Wall Loop - 1

Filament - Bamboo ABS Olive Green

These work fine. If you want it stronger (not needed IMO) you can increase both.