PTFE Coupler Straightener - ★ FIX ★ Failed to feed the filament into the toolhead
Copyright Claim
PTFE Coupler Straightener - ★ FIX ★ Failed to feed the filament into the toolhead
Boost
65
135
31
Print Profile(1)
(Standard) 0.2mm layer, 2 walls, 15% infill
Designer
26 min
1 plate
Boost
65
135
31
0
182
146
Released
Description
This model helps to straighten the PTFE tube as it enters the PTFE coupler. A bend in this point is a frequent cause for the “Failed to feed the filament into the toolhead” error.
Warning: If you print a third party profile you may not be getting the latest version or the highest quality print.
If you like this project, please don't forget to ❤ Like and ★ Rate!
Comment & Rating (31)
All
Print Profile
(Standard) 0.2mm layer, 2 walls, 15% infill
printed out great!
0
Reply
Print Profile
(Standard) 0.2mm layer, 2 walls, 15% infill
Quick print and great design.
0
Reply
Print Profile
(Standard) 0.2mm layer, 2 walls, 15% infill
fits like a glove
0
Reply
Print Profile
(Standard) 0.2mm layer, 2 walls, 15% infill
So far so good :D
0
Reply
Print Profile
(Standard) 0.2mm layer, 2 walls, 15% infill
printed perfectly in petg and supports the ptfe tube well. Snug fit on the coupler.
0
Reply
Print Profile
(Standard) 0.2mm layer, 2 walls, 15% infill
printed at 97% it fit perfectly for me in PLA + high speed using XINGTONGZHILIAN filament.
(Edited)0
Reply
Print Profile
(Standard) 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
(Standard) 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
(Standard) 0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
(Standard) 0.2mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
© 2024 MakerWorld