Air Scoop / Intake / Vent for Car Window

Copyright Claim

Air Scoop / Intake / Vent for Car Window

Boost
51
80
7

Print Profile(1)

All
P1P
P1S
X1
X1 Carbon
X1E
A1

⭐ Original Profile: Quick and Strong - 0.2mm layer, 4 walls, 25% infill
⭐ Original Profile: Quick and Strong - 0.2mm layer, 4 walls, 25% infill
Designer
9.7 h
2 plates
5.0(2)

Boost
51
80
7
0
55
22
Released

Description

Having a roadster I never thought i'd need A/C, so when I bought my MX5 I never bothered looking for the version with A/C, oh boy I was wrong…

 

On the hard summer days, you have to keep the top up to avoid getting burned from the sun and then you'll start boiling on the inside, so I designed these universal Side Air Scoops that are hold in place on the window's glass and scoop air inside. Even at lower speeds (40km/h) you can already have quite a nice cooling.

 

The outlet has a cap that goes over, with an angle of 25 degrees allowing you to adjust where you want the air to go simply by rotating it! I included versions for the Left and Right side.

 

I designed this for my Mazda MX5 NB but it's compatible with any car. If your window glass is thicker or thinner, you can easily remix. If you can't, just let me know and I'll gladly modify it for you!

 

Check the images for the best printing orientation!

Comment & Rating (7)

Please fill in your opinion
(0/5000)

As a fellow Miata owner, i can relate. After owning this car for over 3 years, i can tell with certainty that it's never a good time to have the top down. When it's hot, its way too damn hot and when it's cold, its way too cold and windy to ever leave the top down.
The designer has replied
1
Reply
that was exactly my biggest misconception of roadster cars ahah I feel exactly the same! it's never a good time to get the top down ahah
0
Reply
Print Profile
⭐ Original Profile: Quick and Strong - 0.2mm layer, 4 walls, 25% infill
tolle Lösung
The designer has replied
0
Reply
Thank you! It's definitely a bit loud, but so is having the window opened :D
0
Reply
tank you for this stl, i print this westerday, and test today, and it work fine, ( PETG BLUE semi-transparent ) of creality, i dont have a picture at this time.
0
Reply
Print Profile
⭐ Original Profile: Quick and Strong - 0.2mm layer, 4 walls, 25% infill
Loving this model and the profile was spot on
0
Reply
Make a hose attachment to shove in your shirt/shorts lol Feel your pain
0
Reply
No more