Bambu P1,X1 Magnetic Poop Chute [REMIX]
Remixed by
Copyright Claim
Bambu P1,X1 Magnetic Poop Chute [REMIX]
Remixed by
Boost
54
136
108
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.8 h
1 plate
Boost
54
136
108
1
516
402
Released
Description
Enjoy the magnetic remix of the original poop chute (link) form a great guy: @ed.burnett25 (link) !
“Yet another poop chute design.” And added some 3M sticking magnets (freely comes with the bambu printer), so the poop chute is now ideal for IKEA KALLAX - if you have small space around the printer, and if the tray has to overhang. Works very well and it's printed with no support. Enjoy!
And thanks Ed!
Comment & Rating (108)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
prints fine but does not fit p1s. needs to be bigger. can see in pictures that it's not big enough and cause poop to fall on the floor and not into bin. you will need to adjust the length without increasing the height. width is also to thin clogs back up into the chute. having it little longer then the chute and 2x thicker would fix the problem. I used bambu filiment 4 nozzle
(Edited)
The designer has replied
1
Reply
this issue will be fixed soon, sorry for this :(
0
Reply
Replying to @Kandur
Was this issue fixed?
0
Reply
wondering if this was fixed, it has the same issue on the X1-C
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
sometime my printer still poops besides the chute.
The blue parts should be a bit higher up, I think
(Edited)
The designer has replied
0
Reply
wow... how ?:D
0
Reply
it just flies out.
0
Reply
prints nice ad very useful. thank you.
The designer has replied
1
Reply
Nicely printed! 👌🙂
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
good model, fills up with a large amount of filament changes in 1 print but for most jobs it works great.
The designer has replied
1
Reply
Thanks for the review! Nicely printed! 🙂
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed perfekt. Petg. Good funktion
(Edited)
The designer has replied
1
Reply
Thanks for the review! Nice print!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
bit too short and had to had an extension on but it works
The designer has replied
0
Reply
Hi i think this custom side panel of the P1P is a bit too wide for he model parameters. But thats just what i think.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed perfectly!
(Edited)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great print.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Just perfect.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
It was good for the most part but I don’t understand why they were the lines towards the base.
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld