Multiple Layer Height Test Calibration
Copyright Claim
Multiple Layer Height Test Calibration
Boost
4
9
3
Print Profile(3)
0.4mm layer, 2 walls, 0% infill
Designer
44 min
1 plate
0.6mm nozzle, 0.3mm layer, 2 walls, 0% infill
Designer
30 min
1 plate
0.2mm nozzle, 0.06mm layer, 3 walls, 0% infill
Designer
54 min
1 plate
Boost
4
9
3
0
13
17
Released
Description
Multiple layer height test model. Good for comparing different layer heights and deciding which to choose.
On 0.6 nozzle there is a problem with the text on the top, it will be also fixed.
0.2 nozzle size is smaller to reduce print time
Checkout my profile for more models: https://makerworld.com/en/@AngryPearl
Comment & Rating (3)
All
Print Profile
0.4mm layer, 2 walls, 0% infill
I cut it at 0.19 because I don't really print at lower quality than that but it worked great.
One thing I would have liked better was to have the bottom one at the lowest quality and the top at the highest but that might be just my preference
0
Reply
Print Profile
0.6mm nozzle, 0.3mm layer, 2 walls, 0% infill
1
Reply
Print Profile
0.4mm layer, 2 walls, 0% infill
(Edited)
1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld