Book Holder with drawer a1 mini compatible
Boost
60
106
10
Print Profile(2)
Full size version
Designer
6.9 h
2 plates
A1 mini version
Designer
7.5 h
2 plates
Boost
60
106
10
0
120
92
Released
Description
includes 2 versions 1 for full size printers and one for the a1 mini.
full size version is 20cm long and 14cm wide and 14cm tall
A1 mini version is 18cm long and 14cm wide and 14cm tall which i found a tad shorter than my books but still works fine
If using raw files I would recommend printing the actual holder on its side (like in the image) as i ran into issues printing it lay flat.
the drawer cavity is around 40mm tall and there is a small tab at the back to stop the drawer sliding all the way through.
Comment & Rating (10)
All
Super simple to print. I used Overture PLA and it looks great - thank you
1
Reply
Print Profile
Full size version
Printed in Polymaker Matte PLA and the sides warped. Not sure if that was a printer issue, first time I have had this happen (only been printing for a few months). The drawer is a very tight fit, would suggest shrinking it just a touch.
The designer has replied
0
Reply
the draw fits perfectly fine for me, what machine are you using? and you are aware you can change the size yourself in bambu studio.
0
Reply
Print Profile
Full size version
nice easy print, ty
1
Reply
printed and the sides warped and then cracked.
0
Reply
Print Profile
A1 mini version
might have been my printer, but the two parts don’t fit the best together.
0
Reply
Print Profile
Full size version
1
Reply
Print Profile
Full size version
1
Reply
Print Profile
A1 mini version
1
Reply
Print Profile
Full size version
1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld