No Print Profile yet. Add one to earn points.
This is a simple but specific holder for a “Xiaomi MIPAD4” tablet.
I had a “broken” MIPAD4 (with battery being dead), and instead of replacing the battery, i now use that tablet in the kitchen and in a “fixed” way (continuously charged through USB-C), on a shelf (allowing some stable manipulation, and with tablet now located at “eye level”).
The design is very simple. I have a “storage box” placed just behind the holder, in order to have some “weigth” on the holder (hence the backplate) and for everything to stay well in place when using the tablet.
Probably a very specific setup / use-case - published it just in case it would be someday useful for someone else.
For reference, the dimensions of the XIAOMI MIPAD4 tablet are (when in paysage mode) :
USB-C port is at mid-height, on the right side (hence the 2 pilars being lower than that). I'm using a 90° angle USB-C connector.
Timelapse of print (here on a Bambu Lab X1C / PETG 0.2mm / no supports needed / really nothing special regarding the print) :
Design done with Tinkercad.