Added Pushfit to the arm, there are 2 versions:
Printed with @0.12mm, 3 perimeters.
I'm happy to share the V2 of my design.
P1P ARC version is very similar to X1 version with the exception of a few changes needed to adapt to acrylic panels:
Make sure the print is strong and rigid, I've printed mine with 4 perimeters, 0.2mm layer height 5 top/down layers, cubic (or gyroid) infill.
The filament guide just fits into arms, you can glue it but it's not necessary
PTFE tube is pushed into the hole, tolerance may vary depending on your filament and printer calibration
PS: I didn't update variants 1 and 3 because I think that the top hook doesn't add much
------------------------------------------------------------------------------------------------------------
A spool holder that allows you to put the spool on the side of the X1 by using the arm provided by Bambu Lab or by printing your own arm with bearing.
I remixed Enrique182's design and created 4 variants, all of them allow to install the coil on the left side of the printer in a fast and safe way.
The 4 variants screw into the back of the X1 at the location for the original arm, I used M3x16 but other lengths work too.
Now let's get to the differences:
I have only tested variant 1 with the following parameters:
PLA Sunlu
0.2 default profile
3 perimeters
Infill 25% gyroid