I was tired of seeing this unused hole on my desk, but I didn't want to make a simple and common cap, I wanted to do something that could come in handy.

This is how I immediately thought of making a drawer to tidy up small objects, such as USB sticks, etc…

This drawer is designed for desks that have an unused hole for the passage of cables, and you want to give it a utility.

The drawer slides on the frame, which remains attached to the desk, when the drawer is open it is supported by 4 magnets, 2 on the frame and 2 on the drawer, in this way if you need the drawer you can detach it very easily.

Print your drawer now and say goodbye to your ugly hole on your desk!

Filament: SUNLU PLA+ Black,White,Mint Green Post-Printing =============

This drawer is made on the basis of a 77mm hole. For this drawer you will also need:

-4 magnets 5x5x5mm

-3 screws 10mm

-screwdriver

-lighter

-glue****

The assembly is very simple, just attach the knob to the circle with a screw, and then with 2 screws attach the circle with knob to the drawer. With the lighter you need to heat where the magnets will be inserted, 2 on the frame and 2 on the drawer. Calmly heating the plastic, when it is soft enough, take a magnet and insert it in the prepared hole, being careful not to damage the lanes (due to the plastic that we have heated) because otherwise the drawer will not slide well.

Once this is done, just take the lane and insert the drawer, making sure that the drawer opens from the correct side, just put a little glue on the frame and fix it to the desk.

If you want to support me: Thanks