Smooth ironing and speed test (pre-programmed) for top surfaces
Copyright Claim
Smooth ironing and speed test (pre-programmed) for top surfaces
Boost
28
100
31
Print Profile(4)
0.2mm layer, 1 walls, 5% infill X1C X1E P1P P1S
Designer
3.5 h
1 plate
0.16mm layer, 1 walls, 3% infill A1 mini
Designer
2.1 h
1 plate
0.16mm layer, 1 walls, 5% infill X1C P1S P1P
Designer
3.6 h
1 plate
0.2mm layer, 1 walls, 5% infill A1mini
Designer
1.9 h
1 plate
Boost
28
100
31
0
187
170
Released
Description
Use this pre-programmed test to find out the best ironing flow and speed for your filament. First panel is 30 speed and ironing flow from 0% to 60% at increments of 10. Second panel is 35 speed and Third is 40 speed. Try the top panel first and delete the bottom two and if you don't find a smooth surface then try the middle panel and delete the top and bottom panels etc.
Save time and aggravation to find that smooth top surface.
Comment & Rating (31)
All
Print Profile
0.2mm layer, 1 walls, 5% infill X1C X1E P1P P1S
good
1
Reply
Thank you for sharing this, very useful.
The designer has replied
1
Reply
Rather disappointingly, it seems for some filaments ironing doesn't help. Not sure if that's good or bad actually! Great to have such evidence for ironing selection though.
1
Reply
Replying to @dtothek89
Some filaments can't handle an additional burn on the surface.
0
Reply
Glad you found it useful
0
Reply
Print Profile
0.2mm layer, 1 walls, 5% infill X1C X1E P1P P1S
worked great!
The designer has replied
1
Reply
Thanks
0
Reply
Print Profile
0.16mm layer, 1 walls, 3% infill A1 mini
Helped my with my ironing settings on A1 mini - highly recommend!
The designer has replied
1
Reply
Glad it helped
0
Reply
Print Profile
0.2mm layer, 1 walls, 5% infill X1C X1E P1P P1S
Thanks, Easy and fast
(Edited)The designer has replied
1
Reply
Good to know
0
Reply
Print Profile
0.2mm layer, 1 walls, 5% infill X1C X1E P1P P1S
Nice and helpfull tool !!!
1
Reply
Print Profile
0.16mm layer, 1 walls, 3% infill A1 mini
very good
1
Reply
Print Profile
0.16mm layer, 1 walls, 3% infill A1 mini
i used a 0.2 nozzle @ 0.06mm layer height and just scaled it down to 0.64mm z height so that there is 3 layers of solid infill over the text in the bottom and before the actual test
1
Reply
Print Profile
0.2mm layer, 1 walls, 5% infill X1C X1E P1P P1S
Works like a charm.
One thing: the SPD text on the backside is mirrored :)
1
Reply
Print Profile
0.16mm layer, 1 walls, 3% infill A1 mini
Helped me sort out my ironing
1
Reply
License
This work is licensed under a
Creative Commons Attribution-NoDerivatives
© 2024 MakerWorld