DeWALT LED Light Box
Copyright Claim
DeWALT LED Light Box
Boost
50
72
20
Print Profile(2)
FRONT
Designer
3 h
1Ā plate
BACK
Designer
1.1 h
1Ā plate
Boost
50
72
20
0
113
155
Released
Description
DeWALT LED Light Box š” š¦
It is recommended to print the BED CLEANER first!
https://makerworld.com/en/models/78594#profileId-82864
Ā
** USE PROVIDED PRINT PROFILES! THEY HAVE
SPECIFIC SETTINGS CHANGED TO CLOSE GAPS
ON FIRST LAYER! **
Ā
Drill hole in side or back panel (or cut in slicer) for
LED strip light wire.
Ā
Make sure print bed is CLEAN before printing.
Ā
REMOVE PURGE LINE RIGHT WHEN THE PRINT
STARTS!!
Ā
NOT FOR COMMERCIAL USE!
For commercial use license visit:
Comment & Rating (20)
All
Print Profile
FRONT
Perfect print š„
1
Reply
Print Profile
FRONT
Thanks for the model. it's a good idea, but apparently because you make logos en masse, you don't pay attention to the little things. the model is very large, which is why the border gets on the model and spoils its appearance. the walls are also excessively thick and the back cover is missing.
0
Reply
Print Profile
FRONT
Perfect print. Thanks!
0
Reply
Print Profile
FRONT
0
Reply
what color is this? look almost perfect matching in picture
0
Reply
Replying to @jamesduke1993
its sunlu yellow pla
0
Reply
Print Profile
BACK
I tried printing it twice. Both times it's slightly too large and bows in the middle a bit.
The designer has replied
0
Reply
It is meant to be tight. But not that tight.. are you getting a little buldging at the seams? Could be filament calibration. Mine fit tight. I do glue them, just so people don't see my bad wiring job š
0
Reply
Print Profile
FRONT
The designer has replied
2
Reply
Thanks for the 5 stars!
0
Reply
Print Profile
FRONT
Turned out awesome
0
Reply
Print Profile
FRONT
Turned out great.
0
Reply
Print Profile
FRONT
0
Reply
Print Profile
BACK
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
Ā© 2024 MakerWorld