Almost all of my 3D-printing bits and parts are now nicely stored in the AMS Stand drawers, but the opened super glue tubes seem either leak or glue themselves shut when placed in the drawers. To solve this issue, I designed this (overly complicated) super glue tube holder, which slots rather nicely to the side of the AMS Stand and holds the tubes upright.

Prints in less than 25 minutes and consumes about 10g of filament. I used SUNLU Matte PLA Back, but anything will probably do just as well. I chose that pretty much just because it's about the cheapest decent filament I've been able to get so far.

The print profile has two versions: “Option A” to be used with the standard sized drawers and “Option B” for the long drawers.
The plates 3 and 4 of the print profile have mirrored versions of the same models respectively, in case you want to place the super glue tube holder to the opposite side of the AMS Stand.

The oval hole for the super glue tubes is 12x22mm, which probably should fit nicely the most commonly available super glue tubes… But if not, let me know in the comments, so I can make this in another sizes!