I made this rack to hold a 10-pack of hobby syringes that I use to hold solvents, lubricants, glues, etc.
If you buy this syringe pack, you should definitely print this holder. https://www.amazon.com/10-Pack-Syringe-Needles-Applicator/dp/B01HFTYINS/ref=sr_1_10?ie=UTF8&qid=1505278113&sr=8-10&keywords=hobby+syringe
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/8DWTz4o14BF
Printer Brand:
Ultimaker
Printer:
Rafts:
No
Supports:
Yes
Resolution:
0.1mm
Infill:
25%
Notes:
You'll need supports on the tray edges and on the rectangular tray opening in the holder, but I removed the supports from the actual holes. I didn't need them.rnrnThis uses thefull bed width on an UM2 Extended+ so make sure you turn off brim.
Category: Tool Holders & Boxes