Christmas Tree Star Topper
Boost
16
31
16
Print Profile(1)
adaptive layer, 3 walls, 15% infill
Designer
3.1 h
1 plate
Boost
16
31
16
0
53
24
Released
Description
Christmas tree topper
Star 180mm
hole 21mm conus to 13mm
Comment & Rating (16)
All
I am using a Bambu Lab P1S printer with PLA filament. It printed very well and looks great on my tree.
(Edited)
1
Reply
Can you please share what printer you printed this on? thanks
0
Reply
Print Profile
adaptive layer, 3 walls, 15% infill
Bad.... And you don't even upload a picture.... I don't recommend it !!
The designer has replied
0
Reply
4 print.. All OK.. In home I have only 2 star..
0
Reply
Print Profile
adaptive layer, 3 walls, 15% infill
three attempts with different filaments and settings. all failed. all three times bottom of Star got out from support
The designer has replied
0
Reply
Printed 4 times.. All without problems.. Problem is on your side :)
0
Reply
Replying to @Magmar
Fifth time - same issue. Tried it for the fifth time. It's absolutely the same problem as the last 4 attempts. The star does not hold in the support and flies out immediately. Fiму trys, five different PLA filaments. Tried changing settings, and speed, and fans, but nothing helped.
I print a huge amount of everything - including tall fragile things, vases, ornaments, toys from a wide variety of filaments. Not a single problem. This star is the first and only thing that doesn't get printed. And it failed in the exact same place. I have X1C.
Thoughts?
(Edited)
0
Reply
I don't know where is a problem..
0
Reply
turned out good
0
Reply
Print Profile
adaptive layer, 3 walls, 15% infill
very nice star, just a bit too weak
0
Reply
got it done even with fuzzy skin... Looks great
0
Reply
Print Profile
adaptive layer, 3 walls, 15% infill
0
Reply
Print Profile
adaptive layer, 3 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld