The pictured prints were done in matte gray and matte black PLA with the “fuzzy skin” feature enabled. (I HIGHLY recommend using the fuzzy skin feature if you have never tried it before.)

I've included three sizes that maintain the same (3/16" or 4.75mm) thickness on all sides. This thickness seems to strike a good balance between minimizing material used and maximizing strength.

Although I designed this with the intention of it being a planter, it also seems to work great as a multi-purpose container for holding pens, pencils, or other things you might find on a desk or bookshelf.

Sizes:

• Small: 3in x 3in x 3in (76.2mm x 76.2mm 76.2mm)
• Medium: 4in x 4in x 4in (101.6mm x 101.6mm 101.6mm)
• Large: 5in x 5in x 5in (127mm x 127mm x 127mm)

Print settings I used:

• 0.2mm layer height
• Fuzzy skin
• 15% infill

If you like this design, consider leaving a tip! I'm a university student that designs planters on the side, so anything helps!

https://www.paypal.me/theprintedplanter