Challenge Coin Display / Challenge Coin Holder two options by PWmodder1027

PWmodder1027

Household>Office

Print Profile(0)

No Print Profile yet. Add one to earn points.

+ Add Print Profile

Boost

Released

Description

Two different options for displaying challenge coins. The first is a tall vertical stand. You will need supports when printing the middle flat, or you can stand it on end and print without supports. The second is a small desktop display. Print top down and the bridging should eliminate any supports. printing on the side may do the same.

For the 3 piece stand there's a 0.2mm tolerance built in for a press fit. If that is too loose, you can apply a small amount of glue.

Like my work and want to say thanks? Buy me a Coffee https://www.buymeacoffee.com/pwmodder1027

Comment & Rating (3)

@RainX1C

I have been trying to print the free standing version of this and it just can not print as aligned in the file. The file comes in as geometry only as its not identified as a Bambu File. Anyone else have any luck here?

@jimidean23

worked fine for me on a P1S. I had to cut the width a little just for it to fit on the plate, other than that, i put the center piece flat on its back, and the side pieces on the flat sides and they printed just fine. I was able to do them all without supports. Just cooling at 100% on overhangs and it worked fine. I am also on a .6 nozzle though.

(Edited)