Inspired by http://www.thingiverse.com/thing:1370241 by gpvillamil, I designed a mount to keep the eero's default orientation but suspend it from under a desk.
Note that the material in your desk may cause interference. The eero blog says "Keep your eero out in the open and elevated — it’s better to place it on a tabletop than on the ground." In my case this wasn't a problem.
Note: this is for the original Eero unit.
Printer Brand:
Prusa
Printer:
Prusa Steel
Rafts:
No
Supports:
Yes
Resolution:
.35mm (fast)
Infill:
20%
Notes:
Make sure there's sufficient support material for the overhangs on the sides.
Category: Parts