Inspired by http://www.thingiverse.com/thing:1370241 by gpvillamil, I designed a mount to keep the eero's default orientation but suspend it from under a desk.

Note that the material in your desk may cause interference. The eero blog says "Keep your eero out in the open and elevated — it’s better to place it on a tabletop than on the ground." In my case this wasn't a problem.

Note: this is for the original Eero unit.

Print Settings

Printer Brand:

Prusa

Printer:

Prusa Steel

Rafts:

No

Supports:

Yes

Resolution:

.35mm (fast)

Infill:

20%

Notes:

Make sure there's sufficient support material for the overhangs on the sides.

Category: Parts