I needed a holder for a relatively large volume of USB sticks, and I also wanted room to hold some pens. This is what I came up with. It holds 22 USB sticks, it has a cup for pens, and a shelf for small items.

The USB sticks are held on a disc that can be rotated, and they are held at a slight angle outwards to make them easier to grab if the spots next to it are also populated. (Angling gives it more of a gap between the drive and the cup)

Print Settings

Printer Brand:

Anycubic

Printer: All-metal Mega

Rafts: No

Supports: No

Resolution: See notes

Infill: See notes

Filament: Econofil (filaments.ca), Duramic PLA, PLA+ Black, Silver

Notes:

The cup (pictured in black) was printed from filaments.ca Econofil PLA at a layer height of 0.3 and using 25% lightning infill. The base was printed in silver PLA+ from Duramic at a layer height of 0.3 and 40% gyroid infill. The holder was also printed in silver PLA+ from Duramic but I used 25% gyroid infill and a layer height of 0.15. I used a lower layer height to ensure that the holes for the USB sticks would print accurately and not have a bunch of ledges to get caught on. This may or may not have been necessary. Feel free to use your own settings, I doubt it's too important.

If this design was useful to you, please post a make!