EGO Edger & String Wall Mount Holder
EGO Edger & String Wall Mount Holder
Boost
13
28
11
Print Profile(1)
0.28mm layer, 3 walls, 20% infill
Designer
1.4 h
1 plate
Boost
13
28
11
0
45
50
Released
Description
This is a wall mount holder for Ego Edger, Stringer.
0.28mm layer height
3 wall
20% + infill
no brim
print without support
Print on PETG is recommanded for strength
Comment & Rating (11)
All
Prints great. No supports. This is in ABS. Two colors cause I ran out of grey mid print. Excellent model. Thank you.
(Edited)
The designer has replied
1
Reply
Looks great!
1
Reply
Here is the printed version.
1
Reply
Print Profile
0.28mm layer, 3 walls, 20% infill
Worked great! Now my trimmer is hanging on the garage wall and I don't have to worry about tripping over it all the time. Thanks!
The designer has replied
1
Reply
thank you for sharing
0
Reply
FYI, this doesn't fit the latest version of either the ST1623T (line-iq string trimmer) or EDX2000 (Commercial straight shaft edger).
Thanks for making it anyway! I combined it with a proslat bracket and although it printed well, the new tools must have a slightly different design because they just don't fit the collar at all. The shaft is also tight. I'll be creating my own in fusion and I'll tag you if you're interested
1
Reply
can't tell from the pic, but will the base that you screw trough sit on a 2x4 or is it wider than that? op/Ace3dprints any chance you will make a version that has a base u shaped that would wrap around a 2x4 stud and has 2 screws one at the top and one at the bottom to be able to screw it on a stud? thank you
(Edited)The designer has replied
0
Reply
Hello Lauretiu, yes this will fit on 2x4 actually is a bit smaller please see photo attached, as far as making U shape to wrap around 2x4 is possible it just will take more filment to prit and time. I will play around and will update to v2 or as new design.. just check back or i will tag you once is out. Thanks for your feedback.
1
Reply
Print Profile
0.28mm layer, 3 walls, 20% infill
1
Reply
Print Profile
0.28mm layer, 3 walls, 20% infill
(Edited)
1
Reply
Print Profile
0.28mm layer, 3 walls, 20% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld