My design for fance hold card. It's super slim

The basic version is to print 2x piece of bottom part (without logo) it can hold 2 card. Designed pices for middle part - it can hold 2 cards inside

I add my logo on one version to mark one side of MagWallet. You can use part without logo for creating your own design - if you do this please share it in comments

For printing use ASA/ABS because of temperature resistant. Wallet can be on sun or hot places and can band if you use other materials.

You will need magnets and just tiny amount of glue (don't put too much - The holes are very tight and the magnet will not align with the surface)

the big one is 8mmx1mm
the small one is 4mmx1mm

Start from one side -> place all magnets (one large and two small) in the same polarity in the holes with a small amount of glue
wait for the glue to dry
place this free magnet on top of these 3 magnets (see photo). Get the next part you want and just press it as it should be and repeat the process.
The most important thing is to always place a magnet with the correct polarity on one part and the opposite polarity on the next part.

Before use, I recommend sanding the area where the magnets are located to smooth out, and also sanding the clipboard on the bottom.
MagWallet just two slides to get the card