Please excuse the paint job on this one (I am hopeless when it comes to painting!)
Another HueForge Hybrid print for you - an oversized Pokemon card of Blastoise, as usual completely Print in Place with NO supports required.
This print uses 5 colours (with Teal repeated for Blastoise). If you only have one AMS, you can swap out the Black for Yellow after the Black is done printing, and make sure you assign both Black and Yellow to the same AMS slot when you send the print to the printer!
For all Bambu Studio / Bambu printers, please download the 3MF file and all the settings will have been applied for you, including the layer swaps.
If you are NOT using a Bambu printer or Bambu Studio, please download the STL instead, and follow the print instructions below:
Print Instructions
For the HueForge part of the print (Layer height 0.00mm to 2.60mm)
For the Blastoise part of the print (Layer height 2.60mm - 31.72mm)
Filaments Used:
Swap Instructions:
Post Processing
You will need to paint Blastoise! I used paint pens to make it easier :)
I used this Blastoise model by neb1236 for this hybrid!
_______________________________________
If you'd like to support me, I now have a Patreon!
Joining will give you behind the scenes information on WIPs, access to a private discord, early access and more!
If you want to sell any physical models I have uploaded anywhere, an unrestricted commercial license is available on the $10AUD tier of my Patreon!
_______________________________________