Everyone loves cute ghosts, but this little guy is trapped inside of a cage! This model is a very simple kit that prints in multiple pieces to allow the thin bars to be strong and not breakable, and is easily assembled without glue. The ghost fits snuggly onto the base, and the sides and top fit snuggly enough to stay together even if bumped or shaken, but are easily disassembled for storage if desired between seasons.
To assemble (A note about the pieces: The back and front pieces have notches on the sides, while the sides do not.):
- Take the base and put the ghost on it. The ghost fits snuggly, so don't worry if you have to give it a little push.
- Take the back piece (any piece will do, but I prefer to start with the back) and put it into the back of the base.
- Take the sides (remember, these two are identical and and they have NO notches on the sides) and put them in the side of the base.
- Take the front piece, which has a window, and put it in front.
- Lastly, take the top and put it on. Line up the pieces and it should all fit and look almost seamless. The cage should almost look as if it's printed as one piece, and there should be no gaps between the edges of the bar pieces.