Apple Watch Charging Stand (No AMS Needed)
Boost
357
602
207
Print Profile(5)
0.2mm layer, 2 walls, 10% infill
Designer
1.1 h
2 plates
(PLA Profile) 0.2mm layer, 2 walls, 5% infill
55 min
2 plates
0.2mm layer, 2 walls, 15% infill
1.3 h
1 plate
Fixed for A1 Mini
1.3 h
2 plates
Click to see more
Boost
357
602
207
4
1.7 k
2.1 k
Released
Description
No AMS is needed for dual-color print.
The stand is designed to hold all versions of the Apple Watch from the SE to the Ultra. Accents on the front & back are printed separately and can fitted in after being printed.
Recommended that you use my print profile, but if not make sure Arachne wall generator is selected for both the stand and Accents
Accents are a tight fit so position them into place and push down on a hard flat surface for a flush fit.
This is the final design in the series of watch and phone accessories - check out the other designs - links below
https://makerworld.com/en/models/127277#profileId-137702
https://makerworld.com/en/models/132925#profileId-144122
Comment & Rating (207)
All
Print Profile
0.2mm layer, 2 walls, 10% infill
I don’t know why, but around the whole for the charger, my printer didn’t print quite as clean. but I guess that’s not the designs/profile fault.
charger fits perfect.
The designer has replied
1
Reply
looks like it might be a seam issue. I have had that with some filaments
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
I surprised my wife by placing this on her bedside table, and she was genuinely impressed with the quality. Printing one next for myself for desktop use. Bonus points for the super tight fit tolerance on the accent pieces!
The designer has replied
1
Reply
looks really nice with the blue accent.
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
verygood
2
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
Very nice!!
1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
Very nice print. Just came out perfect. Thank you for your work.
1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
thanks for your efforts, came out beautiful.
1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
great solution to my wife’s penchant for leaving her Apple Watch charging on the floor!
1
Reply
Print Profile
Fixed for A1 Mini
nice print ! and nice design ;)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice 👍
0
Reply
thank you ! easy print :)
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld