AMS Dry Pod Collection - All 7 Slots
Remixed by
Copyright Claim
AMS Dry Pod Collection - All 7 Slots
Remixed by
Boost
86
155
40
Print Profile(1)
0.16mm layer, 6 walls, 20% infill
Designer
22.7 h
1 plate
Boost
86
155
40
10
445
263
Released
Description
I was tired of searching all over for all seven of the AMS desiccant containers so I compiled them all on one plate for EZ printing. I included the one that utilizes the rectangular hydrometer from amazon. Best results I have found was using a PLA-CF with Babmu PLA support material for the cleanest print.
Comment & Rating (40)
All
Print Profile
0.16mm layer, 6 walls, 20% infill
good job 👏🏼
0
Reply
Boosted
Printed nice and clean!
0
Reply
Print Profile
0.16mm layer, 6 walls, 20% infill
no issues.. good to go.
only printed the lower rear pieces from this file
(Edited)
0
Reply
Boosted
Print Profile
0.16mm layer, 6 walls, 20% infill
printed in bambu pla cf looks great , fit together perfectly
0
Reply
great printout. PETG used
0
Reply
Un buen modelo, no tuvo complejidad para imprimir y es bastante útil, gracias!
0
Reply
Print Profile
0.16mm layer, 6 walls, 20% infill
needed the cap first printed very well
0
Reply
Print Profile
0.16mm layer, 6 walls, 20% infill
(Edited)
0
Reply
The small containers do not fit into the new AMS!
In the original model this has been fixed.
The designer has replied
0
Reply
copy! I was unaware of the AMS change. will add an updated plate for both versions soon. thanks!
0
Reply
I like the looks of the front containers and the swing open tops, but they are not just a great fit like the ones out there with the notch on the back that make a nice snug fit when dropping them down in the AMS
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld