A Multipart Pinecil Case remix that fits on A1 mini sized bed.
Based on very versatile case from @orax
This case can house:
- a Pinecil soldering iron with a short tip installed
- 4 spare tips (short or long): allowing you to have a full set available in the case. Long tips can only fit in the storage slot. They will not fit attached to the pinecil
- 2 spare M2 x 3mm screw
- a 2mm black mini screwdriver
- a silicon USB-C cable (compatible with the 1.5m cable sold by Pine64)
- a 3d printed reel of solder
- a small accessory slot (such as a piece of de-soldering braid)
For each side, you should fit the insert part into the cover part and make sure everything fits then you can glue each cover with their respective insert.
With both side assembled, you should be able to align them and insert a length 1.75mm filament in the center holes to act as a hinge.