Print at 100% infill with a layer height of 0.08mm with a base layer of 0.2mm

Filaments Used:
Inland Black PLA Transmission Distance: 5
SILK PLA mika3d silk red Transmission Distance: 5
SILK PLA mika3d silk orange Transmission Distance: 5
SILK PLA mika3d silk salmon orange Transmission Distance: 5

Swap Instructions:
Start with black
At layer #5 (0.52mm) swap to silk red
At layer #7 (0.68mm) swap to silk orange
At layer #10 (0.92mm) swap to silk salmon orange for the rest.

The colors you use dont have to be exac. If you sue a different brand of filament with similar colors I'm sure you will get a similar outcome, if not better. I would reccommend you to wait for the build plate to cool so it will pop off easily. You risk damaging if if trying to pry it off.

Post a photo of your make and review if you like it. The image shown was printed on standard speed on my Bambu P1P.