Tennis ball holder (your dog could like it)
Copyright Claim
Tennis ball holder (your dog could like it)
Boost
20
24
3
Print Profile(2)
Print as a single part with supports
Designer
1.1 h
1 plate
Print as two parts and assemble with M3 screws (standard part, not the thicker version)
Designer
1 h
1 plate
Boost
20
24
3
0
28
40
Released
Description
Summary
This design is a tennis ball holder to clip on your belt. It is made in two parts "Tennis ball holder" and "Clip" to make the print easier. The two parts are assembled by 4*M3 screws of 5 or 6mm.only the base of the spherical part require supports.
A model including both parts is available if you use soluble support or if you are very confident in your supports quality.
The part "Tennis ball holder thick" is a thicker version if you like more rigidity.
Comment & Rating (3)
All
Print Profile
Print as a single part with supports
0
Reply
Print Profile
Print as two parts and assemble with M3 screws (standard part, not the thicker version)
0
Reply
Print Profile
Print as a single part with supports
0
Reply
No more
License
This work is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld