A1 / A1 mini Extruder Front Cover Part
Copyright Claim
A1 / A1 mini Extruder Front Cover Part
Boost
16
19
6
Print Profile(1)
0.2mm layer, 2 walls, 100% infill
Designer
48 min
1 plate
Boost
16
19
6
1
57
31
Released
Description
– Deutsche Übersetzung weiter unten --
An extruder cover for the BambuLab A1 / A1 mini. AMS is required because it is multicolored.
Hold the original cover at the bottom and carefully pull it forward.then remove at the top.
Assembling the printed cover in reverse order.
Printing time only 40 minutes!
I recommend PETG as a material due to its flexibility and 100% Infill.
-------
Ein Extruder Cover für den BambuLab A1 / A1 mini.
AMS ist erforderlich, da mehrfarbig.
Das original Cover unten anfassen und vorsichtig nach vorne ziehen, danach oben abnehmen.
Montage des gedruckten Covers in umgekehrter Reihenfolge.
Druckzeit nur 40 Minuten!
Als Material empfehle ich, aufgrund der Flexibilität, PETG und 100% Infill.
Comment & Rating (6)
All
Print Profile
0.2mm layer, 2 walls, 100% infill
(Edited)
The designer has replied
1
Reply
Very good and nice color !!!
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
The designer has replied
1
Reply
Thank you :)
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 100% infill
Other Issues:the eye never stayed on as expected when turning needs improvement
The designer has replied
0
Reply
Beginner mistake :) Since everyone else isn't having any problems, message me and I'll help you with your settings :)
(Edited)1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld