LLG Controller Grip
Copyright Claim
LLG Controller Grip
Boost
14
19
6
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
1.2 h
1 plate
Boost
14
19
6
1
167
31
Released
Description
Controller grip similar to the Nintendo Switch Joy-Con Grip.
Tolerances might be an issue on the latch depending on your printer and slicer settings.
Can be printed with or without supports depending on the orientation. If you are printing flat, use supports, if printing upright, supports aren't needed.
Filament: PLA/PLA+
Infill: 30%+
Also avialable on Thingiverse
https://www.thingiverse.com/thing:6315454
Comment & Rating (6)
All
Thanks sharing
(Edited)The designer has replied
1
Reply
I did 30% and seemed pretty sturdy.
0
Reply
Thank you kind sir!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I was very skeptical but this thing actually works!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
© 2024 MakerWorld