Bambu Lab X1 and P1 storage box for hotend and small parts with bigger compartments
Remixed by
Copyright Claim
Bambu Lab X1 and P1 storage box for hotend and small parts with bigger compartments
Remixed by
Boost
10
28
9
Print Profile(1)
0.2mm layer, 2 walls, 10% infill
Designer
4.9 h
1 plate
Boost
10
28
9
0
27
27
Released
Description
just a remix with bigger compartments to allow fitting in tweezers, side cutters, and bambu liquid adhesive
Comment & Rating (9)
All
Print Profile
0.2mm layer, 2 walls, 10% infill
Tolle Toolbox für den Bambu Drucker. Mit PETG gedruckt. Sehr gute Arbeit
1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
Great tool box for all of my small printer tooling!
1
Reply
does not fit hot ends! off by a few mm! useless junk. DO NOT PRINT!
The designer has replied
0
Reply
you need to have the fan installed on the hot end for it to fit like in the picture like when buying the complete hot end assembly
1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
I was hoping that the other makers having problems with fused hinges was just some mistake on their part, but I don't think that is the case anymore. I started with a filament that was decently tuned (and dried) and had fused hinges. I then tried my absolute tuned in print profile (I use this profile for a commercial design I sell) and still got fused hinges..
I don't doubt that the model prints perfectly for the creator, but I can say that with my tuned filament profiles I had fused hinges.
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld