Moon lamp Ø20cm, with table stand for E27 socket by Ehrnberg

Ehrnberg

Household>Decor

Print Profile(4)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

0.08mm layer, 2 walls, 15% infill

Designer

15.5 h

1 plate

5.0(5)

Table stand for moon lamp

Designer

7.1 h

1 plate

5.0(4)

Table Stand A1 mini, Ø17cm, 0.2mm layer, 3 walls, 5% infill

4.3 h

1 plate

For A1 mini, Ø17cm, 0.2mm layer, 2 walls, 15% infill

12.8 h

1 plate

Boost

129

Released

Description

Lithophane Moon Lamp with Table Stand. The moon has a diameter of 20cm.
The uploaded print profile is with layerhight 0,2 but adapted to 0,08 at the top of the sphere for a smoother finish.
Support is not necessary.

I have designed a simple table stand for the lamp. The table stand is made to fit an E27 socket that can be screwed into it. The table stand is printed at a layer height of 0.2 with rosegold silk filament. I have used tree support on the overhang in the middle of the stand. If adapted a bit, it would be possible to turn this into a ceiling bracket, so the lamp could hang from the ceiling as well.

The file can be used exactly as you wish 😊 Modify it, sell it, do what you want - it's up to you. I have only made this design to make a lamp for myself and have no plans to sell them.

I hope you enjoy the design!
Happy printing!

Comment & Rating (24)

@pab1o90

Print Profile

0.08mm layer, 2 walls, 15% infill

Almost perfect without supports on the moon 😉

The designer has replied

@Ehrnberg

Wow that looks great! :D Thank you for sharing!

(Edited)

@pab1o90

Replying to @Ehrnberg :

Thanks! 😉

@Mystery_94

Print Profile

0.08mm layer, 2 walls, 15% infill

Thank you very much for this project. It worked out wonderfully 😍👍🏼

The designer has replied

@Ehrnberg

So glad that it worked out for you 😍 Thank you for sharing it with me!

@Dimi

Boosted

Print Profile

0.08mm layer, 2 walls, 15% infill

beautiful

@pab1o90

Print Profile

Table stand for moon lamp

Base made with Geetech silver silk, fits perfectly

@Mystery_94

I have tried to print it twice and both times failed after about an hour. As soon as the base gets wider it prints too far out. Printer: X1C Filament: Bambu PLA Basic Jade White Settings: As you described above

(Edited)

The designer has replied

@Ehrnberg

That sounds strange. I have made about 5 of these now, and never had one failing :( Have you calibrated with your filament before printing?

@Ehrnberg

Hi again. I have now attached the print profile, that I have used for those I have printed :) https://makerworld.com/en/models/143817#profileId-226953 I hope that it will help you.

@Mystery_94

Yes, I have adjusted the filament I use in the settings.