Marble Run 003 launch platform / redesigned posts
Copyright Claim
Marble Run 003 launch platform / redesigned posts
Boost
37
53
17
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.8 h
1 plate
Boost
37
53
17
1
140
47
Released
Description
If too many marbles are used, they often block each other at the launch platform posts. The new design and position of the posts reduces this issue.
Interested in more Marble Run items? Check out https://makerworld.com/en/@mplusm
Comment & Rating (17)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
great design. only seen a ball stand perfectly at the last triangle once. haha
The designer has replied
0
Reply
Take a picture if that happens again 😁. Will certainly find a solution for such cases.
Joking... there's probably never going to be a 100% solution. Thank you very much for your rating 👍🏻
0
Reply
Replying to @MplusM
@mplusM It was about the 3rd test trip for the 5 balls a red one stood perfectly on the triangle. I told my son.. well, its better then it was. Hasnt had a hangup anywhere since.. so its definitely a huge improvement. Now if someone can figure out that last little corner where the marbles get stuck next to the elevator.
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
Eine der besten Änderungen an der Kugelbahn. Es bleiben keine Kugeln mehr hängen.
Super Teil, danke für das bereitstellen der Daten.
The designer has replied
0
Reply
Vielen Dank für deine Rezension! Solche Anerkennungen spornen an weitere Verbesserungen und Addons zu kreieren.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
works great. much less blocking.
thanks!
0
Reply
any plans to make it compatible w the A1 mini?
The designer has replied
0
Reply
Not at the moment, but I'll see what I can do. However, since MW changed the bonus system, the effort is no longer justified.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Works great.
The designer has replied
0
Reply
Thanks! 😀
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice change, marbles don't stuck like the original one.
The designer has replied
0
Reply
Thanks! ☺️
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Druck kam sauber raus und passt sehr gut.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
© 2024 MakerWorld