Castle in the Sky Laputa Robot by JonLee

JonLee

Art>Sculptures

Print Profile(4)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

Laputa Robot

Designer

2.6 h

1 plate

4.7(17)

0.2mm layer, 2 walls, 10% infill

2.2 h

1 plate

4.4(5)

0.2mm layer, 2 walls, 15% infill

2.4 h

1 plate

4.5(4)

0.16mm layer, 2 walls, 15% infill, Manual supports, *fixed*

2.6 h

1 plate

Boost

175

270

358

264

Released

Description

Laputa Robot with Articulated Arms and Legs!

It's an easy print and perfect for those who love Studio Ghibli’s Castle in The Sky.

Prints perfect with PLA and PLA+

I made a profile that has the right scaling so the parts should snap together

Check out my youtube video of the print here https://www.youtube.com/watch?v=viFvuTst3Vg

Please share images of your prints, I'd love to see them!

Notes

I have experimented multiple times on the profile and found this to be the best. However not all filaments are the same. In the event that pieces don't fit, decrease the scale by 2% until you get the right fit.

The lighter Laputa Robot is ESUN PLA+ Bone White

The other is ESUN PLA+ Olive Green

I also used ESUN PLA+ Fire Engine Red for the center chest piece which is optional

You can find the orginal files on thingiverse, the first is the Laputa Robot and the second is a revision to the front chest piece.

Comment & Rating (32)

@user_2816876008

底面太大了，我缩小了5%完美契合。另外手脚连接处和手的爪子要加支撑，要不很容易翻车。最后感谢您发布的模型，童年回忆 ----------------------------------------- 2024.1.8更新一张上色后的样子

(Edited)

@virusburger101

Print Profile

Laputa Robot

Works great and gf loves it. However the bottom part that connects the legs to the body did not fit the pins correctly so I had to super glue the bottom cap only the lower body connector. Other than this everything turned out great!