I am a huge fan of Venom, the movie, so decided to find a nice Venom picture to turn into a HueForge piece. This is my first time playing with HueForge.

To print this follow the instructions below:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA BambuLab Matte Charcoal
PLA BambuLab Matte Latte Brown
PLA BambuLab Matte Ivory White
PLA BambuLab Matte Mandarin Orange

Swap Instructions:
Start with Charcoal
At layer #7 (0.64mm) swap to Latte Brown
At layer #9 (0.8mm) swap to Ivory White
At layer #17 (1.44mm) swap to Mandarin Orange for the rest.