Very sturdy, carries soap or multiple shampoo bottles.
Optional hooks for washcloths or other utensils on the underside.

Fits 18, 20, 22, 25 and 28 mm shower rails.

Easy to print and easy to mount.

Note:

If none of the download options fit your shower rail, you can scale all parts of the next suitable variant in the slicer. The scaling percentage is calculated as follows:
100 * [desired diameter] / [diameter of used download option]

Printing:

Recommended settings: layer height 0.2 mm, line width 0.6 mm, 2 wall lines, 15% triangular infill.

Assembly:

Please follow the scheme above (last picture).

The hooks (for washcloths ) are optional. They attach with a screw thread, and depending on your print configuration, once tightened, they may not line up as properly as in my photos. This can be corrected in a number of ways:

• if the hook rotates too far, it can be fixed in the right position with some glue in the thread,
• if the hook does not rotate far enough, sanding down a few hundredths of a millimeter at the end of the screw may help,
• another alternative would be (when printing the hook) to vary the "XY Size Compensation" parameter in PrusaSlicer (or "Horizontal Expansion" in Cura) by a few hundredths of a millimeter for a tighter or wider fit.