Kitchen Foil Cling Wrap Quiver Holder
Copyright Claim
Kitchen Foil Cling Wrap Quiver Holder
Boost
23
63
28
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.7 h
1 plate
Boost
23
63
28
0
65
59
Released
Description
This is a straightforward holder designed for kitchen foil, such as aluminum foil or cling wrap.
The inner dimensions for the quivers are 50mm x 50mm, which accommodates most regular sizes that are typically 45mm x 45mm. However, I recommend measuring to ensure it suits your specific needs before leaving a negative review. Feel free to let me know if you require different sizes.
To assemble, insert the connecting rod into the corresponding openings in the quivers and then apply double-sided tape to the back. If the connection to the quivers feels too loose, you can use super glue (if printed in PLA). I incorporated a 0.2mm tolerance into the design to facilitate easy assembly.
Comment & Rating (28)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Perfect for my silicone matts
The designer has replied
1
Reply
Cool!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed out three of these. work great for sorting out the cupboard
The designer has replied
1
Reply
Thank you for feedback AND even posting pictures. Greatly appreciated!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Used end of rolls for this. Worked perfectly.
The designer has replied
1
Reply
Very nice prints. Thank you for your review and sharing your pics.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
👍
The designer has replied
1
Reply
Thank you for your review!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
bien
The designer has replied
1
Reply
Thank you for your review.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
very functional the mrs loves them
The designer has replied
1
Reply
Thank you for your review.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
Bed Adhesion Issue
The designer has replied
0
Reply
Sorry you had such a bad result. However, a bed adhesion issue is not related to the print profile but your print plate so this rating is not fair.
For best adhesion clean your print plate only with pure soap and water (no Isopropyl) and/or use a Textured Plate.
If you want to be 100% sure disable the AUX fan. It's not possible to do this in a print profile so it's up to you.
I printed all of three of the above on the same Textured print plate and none of them had adhesion issues.
(Edited)1
Reply
I used a textured plate but in my opinion the temperature for the bed plate is too low
0
Reply
Replying to @Smutje77
Hhhm, I didn't change the default setting. It's what Bambu recommends but maybe you are right.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
Thank you for your review!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
Thank you for your review,
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
Thank you for your review.
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld