Redesigned version - simple side holder for 3 pieces of BambuLab plates - left sided version.

This mount is based on my original version, with a few design tweaks and minor improvements, and is now available for both sides.

Modifications and improvements:

- rounded shape of slot guideways, smoother surface shape
- defining the position of the printing plates at the end of the slots using slopes
- adjusting the shape and increasing the clearance of the dovetail grooves
- addition of the side wall of the holder base
- new replaceable logo

The holder is fixed and centered on the printer side with two pins. The inclined plane of the holder prevents the plates from being pushed out.

The pins fit exactly into the two holes in the bottom of the Bambulab X1C. To attach the holder, you need to tilt the printer back slightly, place both pins in the bottom holes and tilt the printer forward.

It is suitable to print from PLA or PETG material and AMS unit must be used to print the logo. There is PETG in the preset profile with generic settings for X1C. Please adjust the parameters of your own filament !!!

Thank You!

NOTE: this was designed for the X1C printer with standard feet, I have not tested with any other…