TRASH BIN
Copyright Claim
TRASH BIN
Boost
51
69
84
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
4.6 h
1 plate
Boost
51
69
84
1
430
427
Released
Description
A quite simple bin for your P1P/P1S. Probably work also with X1 but i didn't try it.
Feel free to improve my design for made it better looking.
I printed that with grass green pla+ from Sunlu.
Comment & Rating (84)
All
Bin came out perfect. no changes needed for adhesion needed.
The designer has replied
1
Reply
Thank you dude!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
awesome fit for p1s poop bin
The designer has replied
1
Reply
thank you, look very nice in black
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The bin is very solid. Other than a couple of minor print artifacts, this came out really well. Also, thank you for not using the p-word for describing this object.
The designer has replied
1
Reply
Thank you so much
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Right off the plate great print for those sample spools.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Easy and quick to print. Well done! (I scaled it down a little bit because I needed it in a small place)
(Edited)
The designer has replied
0
Reply
Thank you so much!
0
Reply
Ok
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
The designer has replied
1
Reply
Thanks dude😉
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld