Dual Riffle Gold Pan
Copyright Claim
Dual Riffle Gold Pan
Boost
35
57
11
Print Profile(2)
160mm wide - 0.24mm layer, 4 walls, 15% infill
1.6 h
1 plate
![[75% Scale]:0.2mm layer, 2 walls, 15% infill](https://makerworld.bblmw.com/makerworld/model/US62e933beff0dad/design/2023-12-21_428a43f52526f.jpg?image_process=resize,w_100/format,webp)
[75% Scale]:0.2mm layer, 2 walls, 15% infill
1.5 h
1 plate
Boost
35
57
11
1
81
88
Released
Description
More perimeters the better for this one! Close up of fine riffles:
Scale to fit your print volume:
Comment & Rating (11)
All
Print Profile
160mm wide - 0.24mm layer, 4 walls, 15% infill
Printed it in PLA-CF, set the layer height to .1 mm and ironed the top surfaces to get as smooth a finish as possible. Inside bottom of the pan came out impossibly smooth, but the outside surface was a little rough. I think the outside of the pan was just too steep to get a smooth finish but it didn’t affect its panning ability. No gold was found. 🙁
(Edited)
1
Reply
came out great and smooth. can't wait to get to River. great for holding skulls in the meanwhile.
0
Reply
Print Profile
160mm wide - 0.24mm layer, 4 walls, 15% infill
good
1
Reply
Print Profile
160mm wide - 0.24mm layer, 4 walls, 15% infill
came out great
0
Reply
thank you for making it a1 mini compatible
0
Reply
Print Profile
160mm wide - 0.24mm layer, 4 walls, 15% infill
1
Reply
Print Profile
160mm wide - 0.24mm layer, 4 walls, 15% infill
1
Reply
Print Profile
160mm wide - 0.24mm layer, 4 walls, 15% infill
1
Reply
Print Profile
160mm wide - 0.24mm layer, 4 walls, 15% infill
1
Reply
Print Profile
160mm wide - 0.24mm layer, 4 walls, 15% infill
(Edited)
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Share Alike
© 2024 MakerWorld