Magic the Gathering Commander (EDH) deck box
Copyright Claim
Magic the Gathering Commander (EDH) deck box
Boost
14
37
9
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
3.3 h
1 plate
Boost
14
37
9
0
67
91
Released
Description
This box is meant to hold 100 sleeved MTG cards (give or take a few) along with a commander in front inside of a top loader sleeve. I also included holes on the sides of the container for magnets (total of 4, 1.66mm thick, 11.95mm diameter) that can be press fit. Holes can be adjusted easily using meshmixer, or I'd be happy to provide the STEP files upon request if you'd like to adjust it in CAD.
Edit: The magnets are measured to be slightly smaller than advertised, but nominally they are 12x2mm (https://www.amazon.com/dp/B07GX7Z4DF/ref=cm_sw_r_apan_glt_i_76C6KBDT2KZJ24RTG00T?_encoding=UTF8&psc=1)
Happy printing!
Comment & Rating (9)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
decent little case for your cards. I like it.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice design, no issues with the print. I did end up buying the recommended magnets in the link but they were 12 mm and the size of the hole for the default print is closer to 15. I was able to use some loctite and secure the 12 mm ones into the hole without any problem
1
Reply
bonjour,
quelles sont les dimension interieur de la boite?
merci
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons AttributionRemixes (1)
© 2024 MakerWorld