This is designed to hold a Phantom 4 battery on a different drone. The mounts are designed to fit 10mm rails at roughly 60mm apart. This is designed to take a DJI P4 power board that sits on lugs at the rear. The lugs can be then melted over to retain the board. The mounting of this board is not yet finalised although it works. The pins may be a fraction off, I just shaved off the edges to fit. WORK IN PROGRESS.

I printed this end-on ie with the lugs pointing down and using support.

Print instructions

Category: R/C Vehicles Summary

This is designed to hold a Phantom 4 battery on a different drone. The mounts are designed to fit 10mm rails at roughly 60mm apart. This is designed to take a DJI P4 power board that sits on lugs at the rear. The lugs can be then melted over to retain the board. The mounting of this board is not yet finalised although it works. The pins may be a fraction off, I just shaved off the edges to fit. WORK IN PROGRESS.

I printed this end-on ie with the lugs pointing down and using support.

Print Settings

Printer Brand: Prusa

Printer: i3 MK2S

Rafts: Yes

Supports: Yes

Resolution: .15

Infill: 100%