The Teufel Cinebar 11 (Teufel Soundbar) has a few holes on the back to mount the soundbar on the wall.
Unfortunately, there is no holder directly from Teufel, with screws or nails I do not want to hang the soundbar on the wall / scratch.

For this reason, I have constructed the holders. These slide into the holes and nestle perfectly to the soundbar. The height of the holders are chosen so that they are smooth at the top and bottom. If you print the holders in the appropriate color, the trained eye recognizes no difference to the soundbar.

Put the holder in the slicer on its side and take at least 8 walls.

You can work with or without infill (see the pictures again).

At the time of publishing, the Cinebar hangs on the black holders with and without infill (see pictures).

If you don't have confidence in your printout / haven't checked the best durability of your filament with a temp tower, I still advise you to apply this drop of super glue.

Make a test print and check with your thumb if the pin withstands the pressure in moderation (see further picture). I also managed to break off the pin, but only with greater force (I remember: Temp-Tower and filament quality).

I am very happy about a Like! About a small donation as well (paypal.me/3DByron)!

Update: The soundbar hangs stable since the end of July on the wall ;)

Keep it simple!

Print Settings

Rafts: No

Supports: No

Resolution: 0,2

Infill: if u want - see pictures

Filament: PLA+ / PETG / ASA / ABS weiß oder schwarz

Notes:

Minumum setup:

Walls: 12

Infill: no need (see pictures)

Bottom: 3-4

Top: 3-4 if you want

Post-Printing without supports you need a file

The bar must be filed slightly free, otherwise the holder will not fit in the soundbar.
Can also be removed carefully with a knife.

Take rather the file!!

See right holder in the picture.

Category: Audio