You still have under a meter of filament left?
Then print a practical smartphone holder for your keychain.
It's no bigger than your mailbox key!

Most people only have one key (bunch) and one phone with them. This minimal holder should not be missing.

Place your phone on the table in landscape orientation and keep your hands free.

I printed it in TPU because it is more comfortable to carry in your pocket. Of course, you can use all the other filaments as well.

I have provided variants in 8, 9, 10 and 11mm.

11mm works well with iPhone 12/13 mini + ISY silicone case.

Other sizes:

iPhone 12/13mini without Case = 8mm.

iPhone 7 without Case = 8mm

iPhone 7 with original Apple silicone case = 10mm.

Huawei 8/9 lite without case = 8mm

If it is wobbly with your phone, scale the next size up or down a few percent to fit.

Standard size: 50x5x14mm

Keep it simple!

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

with or without

Filament:

TPU recommended, but not required.

Notes:

TPU - 2g - 0.71m

Layer Height: 0.2mm

Line Width: 0.4mm

Wall Line Count: 2

Top/Button Layers: 4

Infill Density: 10%

Infill Line Distance: 6mm

Infill Pattern: Grid

or

TPU - 2g - 0.55m - no infill

Layer Height: 0.2mm

Line Width: 0.4mm

Wall Line Count: 2

Top/Button Layers: 4

Category: Mobile Phone Holder